Candle-bent Fine Line stringers bring a lean line quality to this Mid-Century inspired design.


Bend the Stringer
Holding the stringer with thumbs and forefingers, place the spot you want to bend in the tip of a candle flame (tea lights work well). Apply a light pressure until you feel the glass soften. Lift the stringer out of the flame to cool and set the angle. Keep the stringer relatively flat as you move on to the next bend. Carbon will burn off in the kiln, so there’s no need to clean.

Safety tips: Wear eye protection— stringers can snap. Allow the bent area to cool before touching.

Make a Part Sheet
Arrange the bent stringers on a 7.5" (190 mm) square of 3 mm Clear. Trim the ends to fit on the sheet, although they don’t need to be perfect. Centering the design will make trimming the part sheet simpler. You can also break off sections and use them to carry the line work to the edge of the sheet. When you’re satisfied with the design, fire the part sheet following the schedule below.

Design suggestions: Mix and match different colored stringers. Play with density of pattern and negative space
 
Rate Temperature Hold
300°F (167°C) 1000°F (538°C) :20
600°F (333°C) 1460°F (793°C) :10
AFAP 900°F (482°C) 1:00
100°F (56°C) 700°F (371°C) :00
AFAP 70°F (21°C) :00

Compose, Fire, and Slump
The fired part sheet will be smooth enough to score on either side. Trim it to a 6" (152 mm) square, then clean it and place the stringer side against the kiln shelf. Cap with a 6" square of Opaline and fire to a full fuse. Finally, flip the shelf side up for a slump firing in a Square Slumper mold (8996).

Materials

Sheet: Clear (001101-0030-F) or Tekta Clear (001100-0380-F), Opaline (000403-0030-F)

Fine Line Stringer: Stiff Black (000101-0507) Red (000124-0507) Deep Cobalt Blue (000147-0507) Sunflower Yellow (000220-0507) Cranberry Pink (001311-0507)

Mold: Square Slumper B (8996)

 


Learn More

If you'd like to learn more about kilnforming glass, check out these teaching studios in your region:

Vitrum Studio Beltsville, MD
www.vitrumstudio.com

O-At-Ka School of Glass Batavia, NY
www.oatkaglass.com

Bullseye Resource Center - New York Mamaroneck, NY
www.bullseyeglass.com/newyork


Copyright © 2014 Bullseye Glass Co., All rights reserved.

unsubscribe from this list
update subscription preferences